32mm waste pipe support

32 mm

Independent 32mm polypropylene discharge or waste pipes, conforming to relevant British Standards such as BS 5254 or BS EN 1451, must be adequately supported with pipe clips throughout their run to the soil stack or manifold

Basis in regulation

BS 5254
Read the source
BS EN 1451
Read the source
Part H
Approved Document H
Read the source

How to check it on site

Ensure that 32mm waste pipes are supported correctly with pipe clips at appropriate intervals to prevent sagging or undue stress on connections.

Common failure

Insufficient support for waste pipes, leading to sagging, water traps, or potential disconnections over time.

Last updated 23 August 2026. This is our editorial summary of publicly available regulation, not building control approval or a warranty determination.

Related dimensions at this stage

Minimum

Minimum Hot Water Storage Capacity

60 °C

Domestic hot water storage systems must provide a minimum capacity to adequately supply hot water at a target temperature, typically 60°C

Minimum

Electrical accessory spacing

100 mm

Electrical socket outlets and switches should be installed with a minimum spacing of 100mm between their centres to ensure adequate access and compliance with wiring regulations

Minimum

Clearance from combustible materials

75 mm

Appliances that generate heat, such as solid fuel burners, must maintain a minimum separation distance of 75mm from any combustible materials to prevent fire

Minimum

Headroom over a stair

2000 mm, reducing to 1900 mm at the centre of a loft conversion stair and 1800 mm at the side

Stairs and landings within a dwelling

Maximum

Smoke alarm siting distances

Within 7.5 m of the door to every habitable room, within 3 m of every bedroom door, and at least 300 mm from any wall or light fitting

Ceiling-mounted mains-powered alarms on circulation routes

Range

Gradient of a branch discharge pipe

18 to 90 mm per metre for a 75 mm or 100 mm branch

Measured along the branch from the appliance to the stack