Structural element tolerances

12 mm

the deviation from specified edges or alignments to ensure it remains within the maximum allowable tolerance, e.g., 12mm.

Specific manufacturers or designers may stipulate maximum permissible tolerances for the placement or alignment of structural elements. These tolerances, such as a maximum 12mm deviation from an edge, are crucial for ensuring the overall structural integrity and fit of subsequent building components.

Basis in regulation

BS 8000-1
Read the source
Part A
Approved Document A
Read the source

How to check it on site

Measure the deviation from specified edges or alignments to ensure it remains within the maximum allowable tolerance, e.g., 12mm.

Common failure

Exceeding stated tolerances can lead to difficulties in constructing subsequent elements, creating unsightly junctions, or compromising structural performance.

Last updated 28 August 2026. This is our editorial summary of publicly available regulation, not building control approval or a warranty determination.

Related dimensions at this stage

Maximum

Wall tie spacing at reveals and movement joints

Additional ties at 300 mm vertical centres within 225 mm of the opening

Within 225 mm of an unbonded vertical edge — reveals, movement joints, wall ends

Maximum

Cavity wall tie vertical spacing

450 mm

vertical spacing of cavity wall ties does not exceed 450mm.

Maximum

Cavity wall tie horizontal spacing (partial-fill insulation)

600 mm

horizontal tie spacing for partial-fill insulated cavities does not exceed 600mm.

Maximum

Cavity wall tie horizontal spacing (full-fill insulation)

900 mm

For cavity walls incorporating full-fill insulation, wall ties must be placed at maximum 900mm horizontal centres

Maximum

Lowest fixing position for straps

150 mm

For any structural strap, the lowest fixing into the masonry or supporting structure must be positioned no more than 150mm from the bottom of the strap

Minimum

Chimney wall thickness and construction

100 mm

The minimum wall thickness for block, brick, or stone chimneys, excluding flue lining, is typically 100mm